9 Traps and Snares And How to Use Them
In a wilderness survival situation, it is imperative to know your way around trapping and snaring animals and fish to use for food. With a few simple tools, a lot of patience, and a little bit of ingenuity, you can set up traps and snares to capture game animals, fish and birds with relative ease.
Traps and Snares For Game
Game animals can be caught using traps, snares, and deadfalls.
To make a ground snare on a game trail, simply tie a “noose” from a line that slips easily (I prefer paracord, but fishing line also works well), either using a slip knot or by feeding the line through a smooth ring (such as a key ring). Tie off the end of the line to a tree or other sturdy object, and place twigs in the ground near the “noose” end of the snare. Then, suspend the “noose” from the twigs you placed in the ground, aiming to get it around the head height of the animal you are hoping to ensnare. The goal is to snare the head of the animal as it runs through the “noose,” so that it becomes trapped by its neck, and its attempts to free itself from the line tighten the snare further. Bait can be used to lure the animal to the snare.
While small snares and deadfalls are useful for trapping smaller game, if you are in an area where larger game are plentiful and you have some time on your hands, you can also create a pit trap. Pit trapping can be used for deer or even elk, if you can dig deeply enough. Making pit traps is very time consuming and labor intensive, as you are essentially fashioning a grave from which the animal cannot escape. Begin by digging a hole in the ground wide enough to accommodate the body of the animal you wish to trap, and deep enough that the animal will not be able to escape once it falls in. If possible, shore up the “walls” of the pit with stones, creating a sort of makeshift masonry so that the integrity of the structure of the pit will not be compromised. Cover the pit carefully with thatchwork and leaves in order to disguise it, and wait. Note: be very aware of where you have placed the trap, lest you fall in yourself!
A deadfall trap is just what it sounds like: ideally, this trap makes the animal dead when it falls on top of it. In order to create a deadfall, find a large rock with a relatively flat surface on one side and use a tripod of sticks to hold it aloft. Bait should be placed at the center of the stick tripod. Make sure the sticks aren’t too solidly attached to one another, or the trap will not fall when the sticks are disturbed by the animal. Nor do you want them to be too weakly connected, lest the trap fall with a change of the wind!
Traps and Snares For Birds
Birds needn’t be shot from the air to be caught for dinner.
If you have a large net in your survival kit and feel like fowl, you may be in luck. By suspending a net between two trees in the flight path of a bird flock, you can ensnare one or more birds by trapping them in the netting. It is important that you leave a fold of netting down at ground level in case the bird should find its way downward—and since this method doesn’t involve any snaring of a specific body part, it is important to check it often if you are utilizing it (in case the bird should escape given time).
Another method that can prove useful for bird-catching is a perch-style snare. Take a small stick and wedge it very loosely into the crotch of a tree branch, baiting the stick if desired. Then, tie a “noose” (similar to that used in a ground snare, although very thin line is advised for bird snaring, such as fishing line) and secure it to the tree, draping the “noose” end over the loosely-wedged stick. When the bird lights upon the stick, the stick should fall under its weight, thus trapping the bird by the feet.
Deadfall for ground birds
Just as you can use a deadfall trap for small game, you can use a similar trap for flightless birds. Using the same technique outlined for the small game deadfall, create a baited tripod of loosely-connected sticks holding aloft a large rock. When the bird disturbs the sticks in an attempt to reach the bait, the rock will fall and crush the bird (or at least trap it in place).
Traps and Snares For Fish
You can catch fish without a hook and fishing line, provided you have a few other tools at hand.
Trapping fish with a net
If you have a net, you can suspend it deep in the water of a river or creek by tying it off to poles place firmly in the ground, either at shore or further into the water. The net should be baited throughout, weighted at the bottom, and checked frequently to see if you have a catch. This is a simple, passive method for catching fish.
This method of fish-catching is painfully simple, but it does limit the size of fish you can catch. What you do is take a two-liter bottle (such as those used for soda pop) and clean it out, removing the label and the cap. Cut the bottle just below the neck, leaving a wide-mouthed container and a “funnel” that the neck has created. Cut off the threads of the bottle, leaving about a two-inch hole in the “funnel.” Place the “funnel” end backwards into the large portion of the bottle, so the neck of the funnel is facing inwards. Affix a line to the bottle, and add weights and bait—then sink your trap and wait for the fish to swim on in.
A line of lines
If you like, you can also make a line of multiple fishing lines in order to catch fish while you attend to other tasks. Here’s what you do: take a strong line (such as sturdy rope or paracord) and string it across a stream, tying it off securely to poles or trees on either bank, leaving it just above or partially submerged in water. Then, tie off weighted, baited hooks on fishing line to the cord and wait. When you return to your lines, you may find that your line of lines has taken all (well, most, anyway) of the work out of your fishing.
Whats your favorite traps and snares for game or fish? Please leave it in the comments below.